Traditional Shutters Fast
Receive shutters fast by ordering our quick ship traditional stock shutters. We keep 36 sizes in stock so you may complete the installation of traditional style shutters fast. We also have over 2,000 additional sizes that are usually manufactured in about two weeks.
Traditional shutters are defined by their narrow 1-1/4 inch louvers. The louvers are precisely tensioned to remain in the desired position. A vertical tilt bar serves as the control mechanism that unifies the louver location. A divider rail is automatically inserted when panels are 40 inches or greater in height, creating a top louver section and a bottom louver section.
Also called colonial shutters, this particular shutter style is often used in quaint intimate spaces. The smaller louvers tend to bring focus to the interior of the room, but can be fully opened for light and visibility.
Stock size traditional shutters are only slightly different from those that are custom made. Stock panels use a wider side style so they may be trimmed after they are received for minor width adjustment. The top and bottom rails are of sufficient size so they may be trimmed to reduce the height. Stock shutter are also only sold unfinished, but they are ready to prime and paint or stain when they are received.
Standard production of stock size shutters requires about two weeks. Some sizes are in stock to get shutters fast.
Order online to receive shutters quick. The order form is easy, straight forward, and secure so you can order shutters fast and get them right into production. We provide all of the specifications necessary, making it easy to measure for and determine individual panel sizes. We carefully review every order and put the panels directly into production to delivery you quick shutters.
- measuring workbook
- color charts
- sample shutter
A shutter unit that only covers the lower portion of a window.
A shutter unit that is made specifically for an individual window opening.
A horizontal bar that creates top and bottom louver sections, allowing the sections to rotate independently.
A shutter unit that has one set of shutters on the top and one on the bottom.
Ornamental wood attached to the wall to the outside of the window opening. Generally used to give the window a finished appearance.
Paint or stain.
Used for mounting custom shutter units to the outside of a window opening and can have either 2, 3, or 4 sides.
A vertical strip that extends the length of the shutter unit hinged to the outside stile of a shutter panel. Generally used for cafe type shutter units.
Measurement top to bottom of the window opening according to our measuring instructions. Or, the desired panel height for café type shutters.
A two-leaf device that connects a shutter to the mounting surface or joins two shutters together.
Movable horizontal slats contained within a shutter panel.
A rectangular cavity in shutter stile for inserting a hinge – allowing a tighter fit to the side of the window or frame.
A single shutter. Most shutter units consist of more than one shutter panel.
A cut or groove along the edge of a stile between panels that allows them to form a joint to reduce light penetration.
Horizontal bar at the top, bottom, or across the center (divider rail).
A shutter unit that has one set of shutters from top to bottom.
A window is considered square if the difference between the largest measurement and the smallest is no larger than 3/16 inches and the difference between the diagonal measurements is less than 3/16 inches.
Vertical bar found along either side of a shutter panel.
Traditional or Plantation.
The number of shutter panels from top to bottom. See single tier and double tier.
Vertical bar used for adjusting the louver position.
Shutter panels and other necessary components (frames, hardware, etc.)
that work together to fit a window opening.
Area just beyond the window opening if there is no existing trim.
Measurement side to side of the window opening according to our measuring instructions.
Vertical sides of the window opening. This area will be used to attach a shutter unit using either the INJ or INH installation methods.